| The
enterprise is created in 1990 for the decision of a task of a
heightening of reliability of basic and sealing elements for
hydraulic cylinders of building-road machines.
From first steps of activity course on creation of the
combined seals from the course on creation of the combined seals
from
For ten years of searchings and researches in the field of
new materials, improvement of modern techniques and designer
decisions at interaction with machine-building factories AGA-ELKОNT
became the main enterprise for manufacture basic and
sealing elements for hydraulic cylinders.
Basic production AGA-ELKОNT - high-quality seals both legs
for rods and pistons of hydraulic cylinder of standard diameters
from 20 up to 250 mm, working in mineral oils environment and
oil-water sludge with parallax purity is not more rough than 14
classes on ГОСТ
17216, viscosity from 12 up to 1500 mm2/c at pressure up to 80
mPa, temperature from a minus 50 up to plus 2000 with and linear
speed up to 10 m/s.
Use of the modern engineering decisions has allowed to supply
impermeability according to a class And on ГОСТ
16514-87. For seals of the basic series the resource at a
warranty period of a service 500 km of run makes not less than
2000 kms.
AGA-ELKОNT makes also seals of hydrojoints (collectors) of
pipelines and, seal of shafts.
More 100 machine-building enterprises complete production by production
of the AGA-ELKОNT.
The conformity of landing places of sealing elements to the
international standards has supplied interchangeability of
production AGA-ELKОNT with foreign analogs. In structure of
machines of seal AGA-ELKОNT work in Czechia, USA, China,
India etc. countries.
Except for serial production AGA-ELKОNT executes the
individual orders for manufacture of basic and sealing elements
both nodes of non-standard types and sizes for the repair
purposes and specific conditions of maintenance, and also for
the import equipment. There is an experience of development and
manufacture of special seals for hydroshock-absorbers, hydraulic
accumulators, gas springs and compressors, pumps and
hydromultiplicators of superhigh pressure, pumps for grit
environments, hydraulic hammer and various hydroinstruments.
The high qualification of the experts and presence of
experimental base allows the corporation not only to support a
reached level of the mastered production, but also is active
messages of operation both on expansion of the spectrum of production,
and on a heightening of its qualitative parameters.
If necessary AGA-ELKОNT in detail will consult the
customer on an optimum choice of basic and obturating nodes for
concrete conditions. Under the engineering requirements of the
customer AGA-ELKОNT will execute all complex of operations on
development both manufacture of legs and seals for hydraulic,
pneumatic and lubricant systems. |
